LED fuLl color module installation

How to make Channel letter?
How to install led modules?
--Led full color led module

LED is the semiconductor light source. It emit less heat, and can save more power than incandescent bulb, LED will not release poison gas as the fluorescent lamp; LED will not need to be driven by high voltage as neon lamp and not easy to be damaged. LED is widely acknowledged as the new high-tech Green products.

LED series –pixel series are high brightness, wide viewing angle, perfect performance. Major characteristic of this LED module include: special design for constant current, which can ensure the LED radiation stability and excellent heat ventilation. Driven by constant current & 12V low voltage, it can ensure the safety and reliability. Encapsulated by conductive epoxy, the products have good performance of thermal conductivity as well as the good waterproof & moisture proof. Every loop can change at the same time.Not only a step or a gradual color change, but also any video can be displayed altogether. Every color have 256 levels of grey scale and there is a total of 224 level of different color in maximum.

Install Guide of Pixel series:

1. Clean the Surface of the LED module
2. Take out the connected LED module, stick the double-faced tape on the back, or use the screw to fix directly
3. Fix the module according to the digital figure, and cut off the connection cable after finished
4. Fix the module with screws in the corner
5. Use silicon glue or hot glue to fix the LED bottom and base
6. Link the cut-off cable and output cable of the power supply with connector
7. Connect module to the controller
8. Test when power on, do water-proof at connection point, and then finished

Step 1: prepare for LED module;

Step 2: stick the double-faced tape on the back module;

Step 3: Place the first module near the drilling hole;

Step 4: Place all the modules one by one ;

Step 5: Cut off the last cable after all the modules finished;

Step 6: Connect the module one by one (Notice: Female plug need to match with male plug.)

Step 7: Connect the power cable to power cable, data cable to data cable;

Step 8: The assembled module;

Step 9: Test when power on;

Step 10: Adjust the illumination;

Step 11: The final product

Please note when system connection:

1. Use one power supply for every 20 LED modules.
2. Distance from the first module to the power supply should be no more than 5 meters. The data cable should be no more than 30 meters.
3. When use the power cable, please note that the current of the power cable should not surpass the normal working current.
4. The quantity of LED module, which connected with one power supply should be the same.
5. Ensure the metal case and the power supply connected with the earth.
6. The most quantity of each controller port is 800pcs module.
7. Do water-proof measure on the last module of each loop.
8. Add protection cover on the drilling hole of the power cable, in order not to lacerate the cable.

Design guide:

When the width of the digital is smaller than 110MM, two modules can achieve the requirement. When the width is around 150MM, we suggest to use three modules or more. In order to ensure the brightness and the uniformity of the LED illumination, we suggest the central distance should be no longer than 70MM.

The range of the best distance from the module to the board is around 100MM ~ 150MM. It will occur dim place if the distance is too short, and the illumination will be too weak if the distance is too long.